In recent years, the interest in developing new technologies to produce energy with low environmental impact by using renewable sources, such as wave energy, has grown exponentially all over the world. Wave energy devices that derive electricity from the sea (currents, waves, etc.) are of particular interest and can be modeled accurately with FLOW-3D.
Multi-Flap, Bottom-Hinged Wave Energy Converter
An oscillating flap extracts energy from the waves of the ocean and converts it into mechanical energy. The arm oscillates as a pendulum mounted on a pivoted joint in response to the water waves. Flaps can be organized into an array creating a multi-flap wave energy converter. An array of 3 flaps is simulated in the CFD simulation shown below on the left. All the flaps are hinged to the bottom and are 15m wide x 10m high x 2m thick. The array is operating in a 4m amplitude wave with a frequency of 10s at a depth of 30m. The simulation shows a complex velocity iso-surface along the central plane which is crucial in studying the effect of one flap on other flaps within an array. While the 3 flaps start off with similar dynamic motions, soon the interacting effect of the flaps renders their motion out of phase. A similar flap energy converter is shown on the right. In this simulation, the flap submerges completely into water at its lowest point. Such energy converters are called Surface Piercing flap energy converters. Both of these simulation examples were provided by Minerva Dynamics.
Oscillating Water Column
An oscillating water column is a partially-submerged, hollow structure. It is open to the sea below the water line, enclosing a column of air on top of a column of water. Waves cause the water column to rise and fall, which in turn compresses and decompresses the air column. This trapped air is allowed to flow to and from the atmosphere via a turbine, which usually has the ability to rotate regardless of the direction of the airflow. The rotation of the turbine is used to generate electricity.
The CFD simulations above show oscillating water columns. Only the part where the water column rises and falls in the hollow structure is modeled in order to highlight the physics captured by FLOW-3D. The simulations convey the similar results except for a different choice of wave generation. The simulation on the left uses a wave type boundary condition, while the one on the right uses the Moving Objects model to generate a moving plunger that in turn produces waves – as done in the lab. A pressure plot in the hollow structure is shown for each simulation. It is important to know how much pressure is generated in the chamber, because eventually based on that pressure the turbine is set into rotational motion.